“Every jeweler knows that they need a crimping tool to work on jewelry and make the best jewelry. The funny thing about that, though, is that not everyone knows how to use the tool, as it is a bit more difficult that you might think and it is not self explanatory or easy to do your first time. You might wonder what you can use it for?
Well, if you’re going to be making any sort of necklace or want to many any jewelry that has ornate rings or other attachments, you might find that you’re going to need a crimping tool. While there are a lot of places to get them, we’ve found that the best crimping tools for the money can be had at http://thediyoutlet.com, available for immediate sending and receiving.
So how exactly do you go about using the tool to its utmost effect? First of all, any set of crimping pliers will have two notches, often called Stations, on the end tip of the tool. The first of these notches which is located furthest from the pliers has a dimple in the middle of it, and this station is used when you need to crop the wire into a figure 8 shape. Then, the other station, the one that’s closer to the handle, will be used to fold the crimp back into shape, so that there’s a nice tubular shape to it.
Now you’re going to want to take the crimp tube and you slide it onto one of the ends of the wire and make sure you add in a jump ring. You’ll then take the wire and feed it back through the crimp you’ve just made. Next, you’ll push the crimp up to the jump ring but be careful not to make it too tight so that the ring can’t move, that’s a big no no and might require some finesse. This is one of the more difficult steps when you’re early on in your crimping career.
Now, whilst holding the crimp in that first station (furthest from pliers), you will use your fingers to separate the wires such that they will be lying on either side of the tube. You’ll then need to squeeze the crimping pliers such that the dimple is brought down between the twi wires, so that each strand is trapped on the opposite sides of the crimp. Don’t use some sort of ultra-firm grip because this will ultimately weaken the crimp. But a nice, firm squeeze is in order, and this process should result in a U shaped crimp. Then, move the crimp to the second statin and let that gentle but firm squeeze get the two sides of the U to squeeze together. Again, don’t jam it hard.
Then you can use the wire cutting portion of the pliers to snip off the excess wire. Now, you have an excellent crimp and you can put your beads onto the wire. When the decorations you want are all in order, you repeat this process on the other end to crimp the other end and voila, you’ve successfully used your awesome new crimping tool.”